9. What purposes is not compressed air used on board ship?
(A) Starting engine
(B) Supply engine for burning
(C) For pneumatic tools
(D) Cleaning equipment
18. The weight, displacement, power, speed and several characteristics of the simulating
vessel by the model are accordingly approximated based on the series of data collected from the
tests of __________ .
(A) shop trial.
(B) mooring trial.
(C) model towing tank.
(D) sea trial.
37. Which system shall the safety and environmental protection policy be stated in?
(A) Safety management system
(B) Emergency safety system
(C) Port state control system
(D) Training, certification and watch keeping system
5. Only chief engineer is responsible for maintaining ______.
(A) Seal Log
(B) Oil Record Book
(C) Chief Engineer Night Order Book
(D) Engine Room Log Book
21. The discharge ________ in the fuel ejection system could ensure that the residual
pressure is maintained in the high-pressure fuel line between injections.
(A) needle valve
(B) check valve
(C) stop valve
(D) safety valve
31. Which type of response will be excited for a shafting system if the frequency of a vibratory
load is equal to a natural frequency of the connected structure or equipment of this shafting
system?
(A) Resonant response
(B) Static response
(C) External response
(D) Transmitting response
37. What is the volume above the piston in a cylinder when the piston is located at BDC?
(A) Bottom volume
(B) Compression volume
(C) Top volume
(D) Cylinder volume
12. The _______ system consists of the components necessary to transmit the power of prime
mover into thrust horsepower for propeller.
(A) main bearing
(B) connecting rod
(C) propulsion shafting
(D) air cooling
17. The _______ consists of ISPP(International Sewage Pollution Prevention) certificate,
operating procedure of sewage plant and maintenance procedure of the sewage plant.
(A) engine room tank sounding log
(B) oil to sea interface log
(C) sewage management log
(D) repair list
33. Which code has the objectives to ensure safety at sea, prevention of human injury or loss
of life, and avoidance of damage to the environment?
(A) International Safety Management Code
(B) STCW Training Code
(C) Port State Control Officer Code
(D) MARPOL Code
39. For operating a marine boiler, which device does not belong to safety devices?
(A) Flame detector
(B) Soot blower
(C) Low-water level cut-off device
(D) Safety valves