阿摩線上測驗
登入
首頁
>
輪機工程(概要)(包括推進裝置、輔機與輪機英文)
>
107年 - 107-2 交通部航海人員測驗_一等管輪:輪機工程(包括推進裝置、輔機與輪機英文)#69786
> 試題詳解
25. 空氣壓縮機之總容量,應在下列何種時限中充儲至定額啟動空氣壓力?
(A) 一個小時
(B) 半個小時
(C) 一個半小時
(D) 兩個小時
答案:
登入後查看
統計:
A(659), B(176), C(83), D(23), E(0) #1813585
詳解 (共 1 筆)
weihan
B1 · 2018/12/18
#3118522
船舶輔機P.194依照船籍協會要求,要安...
(共 95 字,隱藏中)
前往觀看
15
0
其他試題
21. Carbon deposits on turbo-charger nozzle ring or rotor blades can results in __________ . (A) low exhaust temperature outlet of the turbo-charger (B) increased revolutions of the turbo-charger (C) stopping of the turbo-charger (D) reduced revolutions of the turbo-charger
#1813581
22. ____ there a designated security officer onboard ? (A) Is (B) Are (C) May (D) Will
#1813582
23. 就船舶推進軸系統的而言,柴油機推力軸與推力軸承其功用敘述下列何者錯誤? (A) 傳遞螺旋槳的推力到船體 (B) 對曲柄軸有定位的作用 (C) 保持軸線的剛性與平直 (D) 承受推力部份徑向負荷
#1813583
24. Which possible reason will not make centrifugal pumps to failure to deliver water? (A) The motor may be sufficient speed (B) Discharge head is too high (C) Air leak in the suction line, or broken or plugged up impeller (D) Direction of rotation of the impeller is wrong
#1813584
26. 下列何者與泵在額定流量時的允許吸入真空度無關? (A) 吸入液體性質和溫度 (B) 吸入液面大氣壓力的大小 (C) 泵的結構參數 (D) 泵排出液面壓力
#1813586
27. 下列有關淨油機中比重盤號數和油水界面關係之敘述,何者正確? (A) 比重盤號數愈小,油水界面內移 (B) 比重盤號數愈小,油水界面外移 (C) 比重盤號數愈大,油水界面內移 (D) 比重盤號數和油水界面位置無關
#1813587
28. 以柴油機為動力的船舶,為回收主機排煙中的廢熱,以提高動力裝置之熱效率的裝置名稱 為何? (A) 過熱器 (B) 輔鍋爐 (C) 廢氣鍋爐 (D) 降熱器
#1813588
29. 船舶之燃油自動拌油機,主要是將下列那兩種油料攪拌混合? (A) 重油與輕柴油 (B) 重油與氣缸油 (C) 輕柴油與潤滑油 (D) 潤滑油與氣缸油
#1813589
30. 何種型式的油壓馬達的起動效率最低? (A) 葉片式 (B) 軸向柱塞式 (C) 徑向柱塞式 (D) 連桿活塞式
#1813590
31. The volumes above the piston at the extremities of its travel are the clearance volume at top dead center position, and the cylinder volume at bottom dead center position. The ratio of cylinder volume to clearance volume is the nominal compression ratio. When the clearance volume and cylinder volume are 2m3 and 8m3 respectively, the compression ratio is what? (A) 0.25 (B) 16 (C) 4 (D) 10
#1813591